线型模式

Synopsis

&FMODE

Description

Controls the display mode fonts of objects.

Characteristics

Read/Write - Number - [1,2]

Constant Values

1 = Hardware Line Fonts
2 = Software Line Fonts

Parameters

Parameter

Description

Hardware Line Fonts

Indicates that the display of objects on the CRT will use the hardware line fonts of the terminal. This usually increases display speed; however, the display (length and type of dashes and spaces) of dashed, phantom, and centerline objects may not match the plotted output.

Software Line Fonts

Indicates that the display of objects on the CRT will use the software line fonts of Unigraphics. Display may take longer than with hardware line fonts; however, the display (length and type of dashes and spaces) of dashed, phantom, and centerline objects will reflect the plotted output. In the software line font mode, foreshortening can also be used to enhance the display.

Parameter	Description
Hardware Line Fonts	Indicates that the display of objects on the CRT will use the hardware line fonts of the terminal. This usually increases display speed; however, the display (length and type of dashes and spaces) of dashed, phantom, and centerline objects may not match the plotted output.
Software Line Fonts	Indicates that the display of objects on the CRT will use the software line fonts of Unigraphics. Display may take longer than with hardware line fonts; however, the display (length and type of dashes and spaces) of dashed, phantom, and centerline objects will reflect the plotted output. In the software line font mode, foreshortening can also be used to enhance the display.