Linear Centerline

Synopsis

obj = CLINE/LINEAR,obj list[,VIEW,view name list]

Description

Creates a linear centerline object. The linear centerline can be created through a set of points or arcs or a single point or arc and lies in the X-Y plane of the work coordinate system.

Parameters

Parameter

Description

LINEAR

Minor word that causes a linear centerline to be generated.

obj list

A list of either points or arcs. The object list must contain at least one object. It may contain up to 100 objects.

NOTE: The objects must be collinear, if they are not collinear, you get a run time error.

Linear centerlines are associative, therefore, if the generating objects are deleted, the centerline is deleted.

VIEW

Minor word that indicates that a view name is to follow.

view name list

A list of strings which represents the view names. If you specify only a single view name for a view name list that corresponds to an object list, then the single view name is used for all the objects in the corresponding object list.

Parameter	Description
LINEAR	Minor word that causes a linear centerline to be generated.
obj list	A list of either points or arcs. The object list must contain at least one object. It may contain up to 100 objects. NOTE: The objects must be collinear, if they are not collinear, you get a run time error. Linear centerlines are associative, therefore, if the generating objects are deleted, the centerline is deleted.
VIEW	Minor word that indicates that a view name is to follow.
view name list	A list of strings which represents the view names. If you specify only a single view name for a view name list that corresponds to an object list, then the single view name is used for all the objects in the corresponding object list.